Grinding disc with defects
A member has reported an incident in which a welder discovered a defect in a new grinding disc. When grinding, the defect could have resulted in the disc cracking leading to possible serious injury or damage. The defect seemed to be a disc steel inner ring that had melted into the disc during fabrication.
It was noted that safe grinding starts and ends with a visual inspection of the grinding equipment. The welder followed recommended process and identified a defective disc before it was used.
Safety Event
Published: 27 October 2011
Download: 
IMCA SF 11/11
IMCA Safety Flashes
Submit a Report
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.
IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.
IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.