Dropped object risk
A member has reported finding the ‘job-made’ lifting hook shown below, rough cut from half inch steel plate, during a routine safety check at a vendor’s shipyard. The lifting hook was lying near a pad eye on a lifting frame for a piece of equipment about the size of an office desk and estimated to weigh 500-750kg. The company concerned confiscated the hook and intend using it for safety training of new staff, as an example of unsafe practice.
The lessons learned by the company concerned were:
- Use only certified lifting gear in good condition;
- Routine inspections of all lifting gear, such as wire rope slings, nylon slings, shackles, hooks, etc. for good condition and proper certification is a necessary practice;
- All lifting frames for equipment should be fitted with properly certified and suitably rated lifting gear when put in service by the rigging supervisor.
Safety Event
Published: 2 October 2001
Download: 
IMCA SF 12/01
IMCA Safety Flashes
Submit a Report
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of all. The effectiveness of the IMCA Safety Flash system depends on Members sharing information and so avoiding repeat incidents. Please consider adding [email protected] to your internal distribution list for safety alerts or manually submitting information on incidents you consider may be relevant. All information is anonymised or sanitised, as appropriate.
IMCA’s store terms and conditions (https://www.imca-int.com/legal-notices/terms/) apply to all downloads from IMCA’s website, including this document.
IMCA makes every effort to ensure the accuracy and reliability of the data contained in the documents it publishes, but IMCA shall not be liable for any guidance and/or recommendation and/or statement herein contained. The information contained in this document does not fulfil or replace any individual’s or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.